陈化时间 meaning in Chinese
assembly time
Examples
- Under a reaction time of 10 minutes and a standing time of 2 hr , the morphology and phases caoxa crystals become approximately constant
反应时间和陈化时间分别为10分钟和2小时条件下，不仅可以使反应得以充分进行，而且产物的物相也不会发生明显变化。 - The influences of w0 ( molar ratio of water to surfactant ) , the concentration of the reactants and the aging time on the morphologies and the sizes of the nanoparticles were studied
研究了微乳液中水与表面活性剂的摩尔比( _ 0 ) 、反应物浓度及浓度比、陈化时间等条件对产物形貌的影响。 - Results show that when the ratio of the ion concentration is 1 . 707 , ph of the reaction is 10 . 0 , reaction temperature is 45 and the aging time is ih , the ultra fine mn - zn ferrite precursor particle can be obtained
得到粒度最小的参量值如下：离子浓度比为1 . 707 ，溶液ph值为10 . 0 ，水浴温度为45 ，陈化时间为1h 。 - As the reaction time and standing time increase , the percentage of calcium oxalate trihydrate ( cot ) decreases and the percentage of the thermodynamic stable calcium oxalate monohydrate ( com ) increases . the metastable calcium oxalate dihydrate ( cod ) is not observed
随着反应时间和陈化时间的增加，三水草酸钙( cot )直接转化为稳定态的一水草酸钙( com ) ，而没有经过亚稳态的二水草酸钙( cod ) 。 - It was demonstrated that the reaction temperature , solvent , concentration of the reactants and catalyst , ageing time affected the particle size and distribution . by controlling these factors or feeding teos step after step , monodispersed and spherical ultrafine sio2 powder could be prepared
讨论了醇、水、氨、正硅酸乙酯、温度、陈化时间等多种影响因素对颗粒粒径及粒径分布的影响，得出了制备超细二氧化硅粒子的优化的工艺条件。