成型温度 meaning in Chinese
forming temperature
Examples
- The optimal molding temperature and pressure of their composite are 140c and 7 . 3 mpa
麻纤维复合材料的最佳成型温度为140 ,成型压力7 . 3mpa 。 - Both ramie and flax are hydrophilic fibers , their thermal stability is not pretty well
麻纤维素含有大量羟基,亲水性强,热稳定性较差,加工成型温度不宜过高。 - The 4 factors , such as specific absorption of aggregate , dosage of fiber , dosage of cement and molding temperature , were assembled properly by orthogonal design method , the effects of the factors on the optimum proportion of asphalt were studied at the same time
采用正交试验方法分析集料吸水率、纤维用量、水泥掺量及成型温度这4个因素对沥青混合料最佳油石比的影响程度。 - 4 . the optimistic resin system and the effect of resin content on the targets performance are discussed by orthogonal experiments , based on which , the moulding process parameters such as temperature , pressure , cycle and post - cure temperature are designed optimistically
4 、通过正交试验确定了最佳树脂体系,确定了含胶量对靶板性能的影响,在选定基体材料基础上,通过正交试验分析,对复合材料成型工艺参数如:成型温度、成型压力、成型时间、后处理温度进行了优化设计,确定了体系的最佳成型工艺参数。 - The approaches of enhancing the mechanical properties of ramie and flax composites were studied in this paper . the effects of surface pretreatment , fiber content , molding temperature and pressure as well as the effect of electron beam , microwave and ultrasonic wave on the mechanical properties of the composites were explored . the experimental results show that : 1
本文以苎麻、亚麻纤维为增强材料,线性低密度聚乙烯( lldpe )为基体,研制了两种麻纤维层压复合材料,研究了麻织物表面处理、纤维含量、成型温度、成型压力等对该复合材料力学性能的影响,得到了性能较为优异的麻纤维复合材料,探讨了复合材料的增强机理。