×

填充混凝土 meaning in Chinese

fill concrete
filler concrete

Examples

  1. Filler concrete joists for reinforced and prestressed concrete floors
    钢筋混凝土和预应力混凝土地板填充混凝土接缝
  2. Comparing the tests of cfrst joints with rst joints , the effect rules of filled - in concrete and geometry parameters of joints on the ultimate bearing capacity were obtained
    通过对比试验,得到了填充混凝土、节点几何尺寸等参数对节点受力性能的影响规律。
  3. The stress contribution in the cross - section is uniformity , and i - shaped steel in web space can result in reduction of stresses , when the concrete was filled into the new dumbbell
    进行了14根钢管混凝土哑铃形试件的偏压试验,其中腹腔内不填充混凝土的构件6根和腹腔内填充混凝土的试件8根。
  4. Stress analysis on cross - section of traditional dumbbell cfst arch rib which concrete filled into the web space and new dumbbell cfst arch rib which concrete not filled into the web space during the concrete was filled into the inner space are introduced in this paper . analysis expressing the stress in the two connecting points of the web plates and the bottom steel tube of the traditional dumbbell is very large when concrete is filling into the web space , and easily causing some great cracks occurred in the weld sealing , which should causing the engineering field
    对钢管混凝土哑铃形拱肋以及新型哑铃形钢管混凝土拱肋在浇注混凝土时的截面应力分布进行了分析,结果表明传统哑铃形截面(腹腔内填充混凝土)在灌注腹腔混凝土时,钢管与腹板交接处将产生很大的应力,容易引发爆管事故,应引起工程界的注意;新型哑铃形截面(腹腔内不填充混凝土而用工字钢加劲)灌注管内混凝土时,截面的受力情况较好,能避免爆管事故的发生,且能简化施工,降低拱肋的自重。
  5. Total of 14 dumbbell cfst columns were tested under eccentric loading , those with 6 specimens which concrete filled into the web space and those with 8 specimens which concrete not filled into it . experimental results indicate that , the portrait strain on the middle section of two type specimens keep on the plane with each loading . the maximum load of columns which concrete not filled into the web space is lower than those filled into it
    试验结果分析表明,两组试件的中截面纵向应变分布在不同的受荷阶段基本能保持平面;腹腔内不填充混凝土的哑铃形柱的极限承载力比腹腔内填充混凝土的哑铃形柱的极限承载力略小,但差值不大,且这种差值随着偏心率的增大而减小。

Related Words

  1. 填充胸罩
  2. 填充床垫
  3. 填充皂
  4. 艺术填充
  5. 填充因子
  6. 填充润滑
  7. 填充模式
  8. 图表填充
  9. 气孔填充
  10. 填充孔
  11. 填充环
  12. 填充混合物
  13. 填充及增强材料
  14. 填充级塑料
PC Version

Copyright © 2018 WordTech Co.