回转中心 meaning in Chinese
center of gyration
center of rotation
center of turning circle
centre of gyration
gyration center
gyration centre
Examples
- In accordance with the principle of mean square root value of shocking force to be a minimum , the concrete position of the rotary center of eccentric gear was determined
根据振动力矩的均方根值最小原则，确定了偏心齿轮的回转中心的具体位置。 - The shocking moment after the complete balance of shocking force can get partial balance through the adjustment of eccentric gear in the attached mechanism
振动力完全平街后机构的振动力矩，可通过调整附加机构中偏心齿轮的回转中心得到部分平衡。 - Through comprehensive analysis of the tbph , the relationship between the induction heater site and rotary axis and the relationship between the support wheel and initial site of the front clapper have been concluded . the minimum nominal curvature radius has also been determined
通过对加热弯管成形的综合分析，得出感应加热器与回转中心的位置关系及支撑轮与前夹头初始位置关系，并确定了加热弯管最小名义弯曲半径。 - In succession , we should test whether the rotation center of the tri - eccentric butterfly vavle was right , brought forward a method to test the seal fit interference , designed the program about the seal fit interference and gave the corresponding results which the program was run
对于三偏心蝶阀回转中心的选择是否合适，本文提出了一个检查密封副干涉的方法，设计了相关的程序并进行了验证，给出了程序运行的部分结果。 - The paper analyzed the struture of the tri - eccentric butterfly vavle at length , defined the tri - eccentric butterfly valve , educed the geometry function and its characteristic about the section of the butterfly disc . the results indicate : the parallel contour line across butterfly disc thickness is normal ellipse , thereby eslablished function relations between its geometry parameters ( long axis and short axis ) of three primary sections of the butterfly disc and the tri - eccentricity ; in order to avoid interference between the butterfly disc and the valve seat as well as the valve body , combining the torque , we obtained the feasible range about the rotation center of the tri - eccentric butterfly vavle
本文主要分析了三偏心蝶阀的结构，给出了三偏心的定义，推导出了蝶板截面的几何方程及其性质，结果表明，沿蝶板厚度的平行截面轮廓线为标准的椭圆形，进而推导出了蝶板几个主要截面的几何参数(长轴、短轴)与三个偏心之间的函数关系；考虑到蝶板启闭过程中避免与阀体及阀座发生干涉，结合蝶板的启闭扭矩，确立了三偏心蝶阀回转中心的适宜区域。