分流口 meaning in Chinese
diffluence col
diffluence pass
Examples
- The operation measures for controlling over - filling ( over - emptying ) are feasible ; the hoisting loads of valve and miter gate are less than their design values respectively ; but , there exists cavitation phenomenon needed to pay attention to the first crossover culvert when the value is near and after whole opening
控制超灌（泄）操作方式可行；阀门、人字门启闭力均小于设计值；阀门接近全开至全开后，输水廊道第一分流口有空化现象。 - In order to solute the problem of diffluence mouth ' s uppityness in the underneath boundary in physics model , the dissertation adopts numerical model to calculate the area from zhuqi to baiyantan , and offer the physics model and the water level of wenshanli and kegong and the diffluence rate . at the same time , the dissertation compare the result between physics model and numerical model in different project
为了解决物模下边界分流口不易控制问题，本文同时采用数学模型进行更大范围即竹岐至白岩潭计算，将文山里、科贡水位、分流比提供给物理模型。同时，将方案计算结果与物理模型相互验证。 - Though the water levels cross one section are almost equal , the velocities differ greatly . at the some cross - section , the velocity in the in the quirk may be double as that on the floodplain . the water surface will rise hi the southern branch because of the improper diffluence ratio , if using the designed diffluence col
淮河入海水道河口段水位值横向分布相差无几，而流速的横向变化较大，泓滩平均流速差最大可达一倍以上，在现有的分流口设计条件下，若按设计的南北汊分流比，南分流口有壅水现象发生，如果南汊分流增大到800m ~ 3 / s左右时，则水流较为通畅。