主刻度 meaning in Chinese
master calibration
Examples
- Constructors set the minor tick spacing to 5 , and the major tick spacing to 20 - reasonable values for the default size of 100
的构造函数把次要刻度设为5 ,把主刻度设为20相对于默认尺寸100来说这两个值是合理的。 - When i created a slider with a range of 1 - 10 , however , i didn t see any need for minor ticks , so i only set the major tick spacing value to 1
但是,当用1 - 10的范围创建滚动条时,却看不到次要刻度,因此只能把主刻度间距值设为1 。 - This resulted in a slider with values of 1 - 10 , which would stick at 1 and 6 exclusively ; the snap - to - tick behavior prevented it from holding other values because it snaps to minor ticks , not major ones
结果产生一个刻度值为1 - 10的滚动条,而且只停留在1和6处;对刻度的行为妨碍了采用其他的值,因为对到了次要刻度而不是主刻度。