English translation for "管间距"
|
- tube spacing
Related Translations:
公园间距: distance between parks 铆钉间距: rivet pitchrivet spacing 构架间距: frame spacetruss spacing 间距离: narrow the gap between 间距调整: spacing adjustmentspan adjustment 列间距: column pitchdistance between columnsdistance of the row to row/distance of the line to lineleadingspace between columns
- Example Sentences:
| 1. | The simplified dynamic models for radiant floor heating are developed . the effect of row distance between the tubes on temperatures are analyzed by using the models
摘要给出了低温地板辐射供冷暖的简化动态模型，作为模型使用的实例，研究分析了地板供冷时管间距对各项温度的影响。 | | 2. | The results show that for all of parameters considered in this study , the friction factor of fin surface without vgs is smaller than that for fin surface with vgs ; the increase of friction factor under low reynolds number is large , but with reynolds number increasing , the increase of friction factor is quite small
实验结果表明：在不同管间距、板间距时，板芯装涡产生器阻力系数均比光板板芯的阻力系数大，并且在低雷诺数时的增幅比较大，随着雷诺数的提高，阻力系数逐渐降低并趋于平缓，且阻力系数增幅大大减少。 | | 3. | The influence of different structural parameters ( diameter and shape of cooling water pipes , distance between cooling water pipes , thickness of stave and cast in bricks ) on the steady state highest temperature and thermal stress of cooling stave was numerically simulated and analyzed by engineering software ansys
摘要采用有限元分析软件ansys计算并分析了不同结构参数（冷却水管形状和直径、冷却水管间距、冷却壁镶砖厚度及冷却壁壁体厚度）对冷却壁最高温度及热应力分布的影响。 | | 4. | Abstract : in the light of the problem of multiple variables restrain in the design of pipe heat exchanger , it is proposed taking three variables , the pipe length , ratio between the table flap space and the shell outer diameter , and ratio between the pipe space and the pipe outer diameter , as optimization criterion
文摘:针对管式换热器设计过程中几何关系的多自变量约束难题，提出了以管长、折流板间距与壳外径之比、管间距与管外径之比三个设计变量作为优化判据。 | | 5. | ( 3 ) based on the experiments data , it has been found that if the emitter discharge of sdi was little , the depth of pipe buried should be shallow , and the distance between two micro holes should be chosen to equal or close the distance between two lateral pipes , if the emitter discharge of sdi was great , the pipe may be buried deeper , and the distance between two micro holes could be greater than the distance between two lateral pipes
根据一维土柱近似的湿润轮廓线初步选定了工程设计参数。在地下滴灌灌水器出流量较小情况下，埋深应浅，孔距应选择和毛管间距相等或接近；出流量大时，埋深可深，孔距大于毛管间距仍可获得较均匀的土壤水分分布。 | | 6. | Dilution and dispersion in constant horizontal flow and bottom multi - port discharging was studied in accordance with the hydraulic model test . the influence of diffusion parameters ( jet angle , jet velocity , number of nozzle , riser space ) and environmental parameters ( water depth , water velocity ) on dilution were analyzed . the experimental results show that environmental parameters have prominent effects on wastewater dilution and dispersion , in addition to that , diffuser design parameters have significant influence on wastewater dilution and dispersion . for bailonggang outfall zone , jet angel is 10 or so , nozzle number is 16 or so
借助于人工模型试验，分析了恒定横流底部多孔排放时扩散器设计参数(射流角度、射流速度、喷口个数) 、上升管间距)及环境参数(环境水深、环境流速)对污水近区稀释扩散效果的影响，实验结果表明，除了环境条件对污水稀释扩散效果影响明显之外，扩散器设计参数对污水的近区稀释扩散也有显著的影响，针对白龙港排放口水域，喷口射流角度宜控制在10左右，喷口个数取16个 |
- Similar Words：
- "管尖" English translation, "管间" English translation, "管间变压器" English translation, "管间的" English translation, "管间过热器" English translation, "管间纹孔式" English translation, "管间隙" English translation, "管间斜距" English translation, "管间耦合" English translation, "管肩鱼科" English translation
|
|
|
