English translation for "thrust augmentation"

推力增大

Related Translations:

water supply augmentation:  增加供水

total thrust:  总推力

diverted thrust:  推力转向的转向推力

piston thrust:  活塞推力

wedging thrust:  楔冲断层

thrust profile:  推力分布图

under thrust:  在有推力情况下

average thrust:  平均推力

thunder thrust:  要么会心一击要么失败

bind thrust:  压刺

Example Sentences:

	1.	Amount of thrust augmentation 推力增加值
	2.	As one of key technologies to acquire the adequate thrust to start the rbcc propulsion system , whether the ejecting technology can produce thrust augmentation in ejecting mode of rbcc is greatly related to whether the potential advantages of rbcc " s high efficiency and low cost can be realized 作为解决rbcc启动阶段动力问题的关键技术之一的引射技术能否在rbcc引射模态获得理想的性能增强关系到能否真正发挥rbcc大幅度提高航天推进系统经济性与高效性的潜在优势。
	3.	The effects of such elements as primary flow total pressure , flow rate , degree of fuel rich , nozzle structure , flying speed and secondary combustion on ejecting mode performance were researched . it was found that thrust augmentation can be achieved on the condition that the flying mach number is above 0 . 7 . to deeply analyze thrust augmentation mechanism in low speed range , the research was further continued by changing secondary combustion organization and aft - body configuration 研究了一次流总压、流量、富燃程度、喷管结构、二次流来流速度、二次燃烧组织对引射模态性能的影响，发现实验样机构型在0 . 7ma以上的飞行条件下可以获得推力增强，而在0 . 7ma以下无推力增强。
	4.	It is of great significance to investigate performance characteristics and thrust augmentation mechanism in rbcc engine . this dissertation just deals with the mixing and combustion flow in a experimental strutjet rbcc in ejecting mode to investigate its performance characteristics and thrust augmentation mechanism by applying numerical simulation technique . the detail is as follows : 1 本文应用数值技术对支板式rbcc发动机，即支板火箭引射冲压组合发动机，引射模态的燃烧与流动现象进行了研究，探讨了rbcc引射模态的性能增强机理，主要有以下几方面： 1

Similar Words：

"thrust at lift-off" English translation, "thrust at maximum reheat" English translation, "thrust at sb with a knife" English translation, "thrust at somebody" English translation, "thrust at springer" English translation, "thrust augmentation by afterburning" English translation, "thrust augmentation by liquid injection" English translation, "thrust augmentation control" English translation, "thrust augmentation device" English translation, "thrust augmentation system" English translation