| 1. | Loose polymer - clad silica fiber
松套聚合物包层石英光纤 |
| 2. | Pcs plastic - clad silica fiber
塑料包层石英光纤 |
| 3. | Pcs plastic - clad silica
塑料包层石英光纤 |
| 4. | 2 ) experimental study on the optical fibers ’ carrying capacity : the capabilities of carrying are carried out through a load - added setup
2 )光纤承载性能的实验研究:进行石英光纤、塑料光纤和液芯光纤承载性能测试的实验。 |
| 5. | The coupling criterion for single - mode pof and silica fiber does n ' t exist because single - mode pof has n ' t been applied widely
由于目前单模塑料光纤还没有得到广泛的应用，也不存在单模塑料光纤和单模石英光纤的耦合标准。 |
| 6. | The theory , method and procedure for measurement of the bending loss of single - model quartz fiber by using fiber bragg grating sensor are introduced
摘要阐述了利用布拉格光纤光栅传感器测量单模石英光纤弯曲损耗实验的原理、方法和步骤。 |
| 7. | At the same time , the experiment of multimode crystal fiber to improve the beam quality of mopa dpl with high repetition rate and narrow pulse width were carried out in this paper
本文还开展了多模石英光纤应用于窄脉冲、高重复频率mopadpl系统改善光束质量的实验研究。 |
| 8. | The variation of optical spectrum of a special kind of optical fiber has been reported after - radiation , which may be used as a new kind of optical fiber filter
摘要报导了2种结构的大芯径石英光纤在辐照后的光谱特性的变化，发现掺杂光纤在辐照后具有光学滤波作用，由此可利用这种特性研制一种新型的光纤滤波器。 |
| 9. | The influence of technological parameters on cobalt content in the coating was studied and a optimal technology was obtained . ( 8 ) the result of sem , om showed that the ni - co coating had smooth surface
( 7 )经过预处理，采用化学镀、电镀的方法在石英光纤表面上电沉积ni - co合金，并研究了电镀工艺参数对镀层中co含量的影响，得出优选的工艺参数。 |
| 10. | However , the capabilities of single - mode pof or bragg grating of the pof should be tested in the laboratory , the coupling for single - mode pof and silica fiber is required , then the properties of single - mode pof and bragg grating of pof can be tested in the laboratory
然而在实验室中，由于要对单模塑料光纤或塑料光纤光栅进行一些性能测试，就需要单模塑料光纤和单模石英光纤的耦合。 |
