English translation for "成膜过程"

film process

Example Sentences:

	1.	Film forming mechanism of imidazole on copper surface 咪唑化合物在铜表面的成膜过程与机理
	2.	Effect of nonsolvents on gelating speed of membrane - forming process 非溶剂对成膜过程凝胶速率的影响
	3.	In recently research , it had been used in many research fields such as molecular recognition , clinical diagnosis , molecular filming , surface property research , poison research and so forth 目前,压电传感器在分子识别、临床诊断、分子成膜过程、表面性质、毒理研究等领域中已得到较为广泛的应用。
	4.	A model is derived for describing the capillary filtration process of asymmetrical tubular ceramic ultrafiltration membranes from the filtration and capillary function theory 摘要以过滤理论和毛细作用原理为基础推导出非对称管式陶瓷超滤膜的毛细吸浆成膜过程的数学模型，并提出测定模型参数的实验方法。
	5.	The common method used by domestic and foreign scientists is removing the cobalt from the surface of the substrate by etching substrate using thin acid solution at room temperature . but the internal co will still overflow during mpcvd 为降低成核及成膜过程中钴的副作用，国内外通常采用的方法是将硬质合金基体在室温下用稀酸溶液浸泡一定时间，从而除去基体表面的钴。
	6.	Mechanical folding test was applied to analyze the crack behavior of dlc films . the results show that the crack appears due to the mechanical stress and the initiation and propagations of the cracks may be suppressed with higher rf power , bias voltage and gas pressure 机械弯折试验结果表明,沉积成膜过程中,应选择较高的气压、基板负偏压、射频功率以及适量的n掺杂来制备抗往复弯折的、耐失效性能优越的膜层。
	7.	( 3 ) the current density is the driving force for electrochemical reaction in the thin films formation process ; the greater the current density , the quicker the electrochemical reaction , the more easily the nuclei formation , whereas the excessive current density would affect the quality of the as - grown thin films ( 3 )电流密度是电化学成膜过程中电化学反应的驱动力，电流密度越大，电化学反应越容易，晶核越容易形成，但过大的电流密度会影响成膜的质量。
	8.	At first , we prepared ps samples at room temperature by electrochemical method , photochemical method and pure chemical method and measured its pl spectrum separately . by compared setup , conditions , formed process and their pl spectra , their formed mechanism and pl spectrum characteristics are analyzed and explained . these three methods all can prepare ps , which radiate visible light at room temperature , but samples prepared by electrochemical method is uniformity relatively and the experiment has more repeatability , so it is extensively applied to prepare ps 本文首先通过电化学方法、光化学方法和化学万法i分别制备出了室温下在可见光区发射光荣光的多孔硅，通过对实验装1置、制备条件、样品的成膜过程及其光致发光闪l ）光谱的比较，分析解释了其成膜机理和pl光谱的特点；认为虽然这三种方法都可以制i备出室温下发光的多孔硅，但相比较而言，通过电化学方法制备的样i品最均匀，实验的可重复性较强，因而是被普遍采用的一种方法。
	9.	( 2 ) . the cyclic isotherms study of behenic acid and dppc surfactants we investigate the cyclic isotherms of behenic acid and dppc monolayer at different surface pressures , based on the existing theory , we discuss the standard free energy of the system on aggregation of the cyclic isotherms ( 2 )纯水亚相上二十二酸、 dppc循环曲线研究河南大学凝聚态物理专业2001级硕士学位论文摘要二十二酸、 dppc单分子膜循环曲线进行了实验研究，对二十二酸、 dppc在不同压力处单分子膜循环曲线进行系统研究，并在现有一些理论模型基础上对其成膜过程分子聚集状态和热力学特征进行了理论探讨。
	10.	By increasing the h2 dilution ratio , it is found that atomic hydrogen can selectively etch amorphous phase and stabilize crystalline phase . from the study on the distance from substrate to catalyzer , choosing a proper distance can ensure the gas fully decomposed , while a relatively low substrate temperature can cause the nanocrystalline particles to lose mobility and keep their sizes . the pre - carbonization process can enhance the nucleation density and make the growth of high quality nanocrystalline p - sic films much easier 实验结果表明：随着工作气压的减小，薄膜的晶粒尺寸有所减小；通过提高氢气稀释度，利用原子氢在成膜过程中起的刻蚀作用，可以稳定结晶相并去除杂相；选择适当的热丝距离能保证反应气体充分分解，又使衬底具有较高的过冷度，是形成纳米薄膜的重要条件；采用分步碳化法可以提高形核密度，有利于获得高质量的纳米- sic薄膜；衬底施加负偏压可以明显提高衬底表面的基团的活性，因负偏压产生的离子轰击还能造成高的表面缺陷密度，形成更多的形核位置。

Similar Words：

"成膜材料" English translation, "成膜的" English translation, "成膜分子" English translation, "成膜氟蛋白泡沫液" English translation, "成膜氟蛋白泡沫液灭火器" English translation, "成膜化合物" English translation, "成膜缓蚀剂" English translation, "成膜技术" English translation, "成膜剂" English translation, "成膜金属线" English translation