English translation for "增容剂"
|
- bulk filler
bulking agents
compatibilizer
Related Translations:
容: Ⅰ动词1.(容纳; 包含) hold; contain 短语和例子可容水三万多立方米的蓄水池 a reservoir with a capacity of over 30,000 cubic metres; 几条小河容不下雨季的全部雨水。 the few small rivers could not hold all the rain that fell during th 增: Ⅰ动词(增加) increase; gain; add 短语和例子倍增 double in amount; 猛增 increase sharply [greatly]; 增减 add or subtract; 增兵 throw in more troops; augment one's forces; reinforce; 产量与日俱增。 output has increa 增容作用: compatibilizationcompatiibilization
- Example Sentences:
| 1. | Increasing consistence in a limited range could decrease the v when epdm was chosen to be the compatible
以epdm为增容剂，结果表明相容性在一定范围增加可以减小泊松比值。 | | 2. | The izod impact strength was increased 48 % and the tensile strength was increased 12 % contrast with pure pp , achieved the highest value when 3 % nano - sio2 by weight modified with silicone coupling agent and pp - g - mah was added
加入3纳米sio _ 2粒子，复合增容剂5份时复合材料力学性能最佳，相比纯pp其冲击强度提高48 、拉伸强度增加12 。 | | 3. | The nanocomposites with exfoliated structure composed of low density polyethylene ( ldpe ) , of organically modified montmorillonite and ethylene vinyl acetate copolymer ( eva ) were prepared through two steps melt intercalating technique using a twin - screw extruder
采用两步法熔融插层工艺，在双螺杆挤出机上制备了以乙烯?醋酸乙烯共聚物( eva )为增容剂的低密度聚乙烯( ldpe )基蒙脱土纳米复合材料。 | | 4. | In this thesis two kinds of coupling agents and maleic anhydride ( mah ) grafted polypropylene ( pp - g - mah ) were employed to act as interface compatibilizers for pp / nano - sio2 . master batches from pp ( 90 ) , nano - sio2 ( 10 ) and coupling agent ( 1 ) were prepared by twin - screw extruder firstly
本课题选用硅烷偶联剂、钛酸酯偶联剂以及自制的马来酸酐接枝聚丙烯作为pp sio _ 2复合体系的界面增容剂，采用母粒法挤出工艺制备了改性pp 。 | | 5. | The composites with different compatibilizers and nano - sio2 content were characterized by means of mechanical testing , differential scanning calorimetry ( dsc ) , x - ray diffraction ( xrd ) , fourier transformation infra - red spectroscopy ( ft - ir ) , transmission electron microscope ( tem ) , scanning electron microscope ( sem ) , etc . the relation between the structure and property of the composites was discussed in this thesis
研究了不同增容剂、纳米sio _ 2含量对复合材料的冲击强度、拉伸强度等力学性能；并利用差热扫描量热分析( dsc ) 、 x射线衍射谱( xrd ) 、红外吸收光谱( ir ) 、扫描电镜( sem )等分析，讨论了复合材料结构与性能的关系。 | | 6. | Sem micrographs of fracture surface showed that the function of rubber reclaiming agents to increase mechanical properties of composites was mainly counted on changing crosslink density of grt and the compatibilizer on improving interface between wpp / grt / wsf . the results showed that practical applied prospects were provided with wpp / grt / wsf composites by two - screw extruder
冲击断面sem表明，增容剂特别是双组分增容剂的加入，能明显增强wpp基体与grt分散相的相容性，明显改善了二者的界面粘合；再生体系的加入，可使grt分散相的粒度明显减小，起到了降低橡胶交联密度的作用，使胶粉更易分散均匀。 | | 7. | In attempt to prepare and investigate the novel high - performance electrically conductive polymer composites , the binary and multicomponent electrically conductive nanocomposites as well as the combined nano and in - situ composites were prepared with polypropylene ( pp ) served as the matrix , expanded graphite ( eg ) as a conductive filler , nylon 66 ( pa66 ) as a modifier , and maleic anhydride grafted polypropylene as an eg intercalater and the compatibilizer of pp - pa66 , based on the state - of - art development in the realm of polymer / inorganic nanocomposites and polymer / polymer in - situ composites domestically and overseas . the main outcomes are obtained as follows : 1
本论文以制备和研究新型高性能聚合物导电复合材料为目的，跟踪和借鉴国内外在聚合物无机物纳米复合、聚合物聚合物原位复合领域的最新研究成果，制备和研究了以聚丙烯( pp )为基体、膨胀石墨( eg )为导电填料、尼龙66 ( pa66 )为改性剂、马来酸酐接枝聚丙烯( gpp )为eg插层剂和pp ? pa66增容剂的二元及多元导电纳米复合材料和纳米复合与原位复合组合复合材料，取得了以下主要研究成果： 1 | | 8. | On the backgrounds of researches inside and outside country , and cooperating experiments with theories analyses , the influence of different processing technology parameters and different sbs modifier sorts on the sbs modified asphalts " properties has been studied . at the same time , their microstructure are observed through fluorescence optical microscopy and scanning electronic microscopy , thus to direct modified asphalt production . on the above conclusion ' s basement , analysing some disadvantages of the storage stability test of sbs modified asphalt in the current specification , a new storage stability test apparatus is developed
本文在参考国内外研究的基础上，采用理论、试验相结合的方法，研究加工工艺参数以及改性剂种类等对sbs改性沥青性能的影响，并通过荧光显微镜、扫描电镜分析其微观形态，从而指导sbs改性沥青的生产；在此基础上，分析我国现行规范用来评价sbs改性沥青储存稳定性方面的不足，开发了新的试验仪，根据动态剪切流变试验结果和微观状态分析，提出一个新的指标? ?离析率r _ s来评价sbs改性沥青的储存稳定性；最后，针对不稳定的改性沥青提出改善措施，研究证明掺加增容剂和稳定剂是行之有效的方法。 | | 9. | The particle size distribution exhibits two peaks due to the different pulverizing efficiency on the two polymers . besides , pan - milling mixing can compatibilize the two polymers in - situ through mechanochemical reactions . viscosity analysis , thermal analysis and ft - ir experiments show that the tg of pp in pp / pa6 co - powder formed by pan - milling mixing and its thermally molded article increased a lot compared to that of pp in pp / pa6 simple blend
力学性能测试及形貌分析结果表明，由于磨盘碾磨混合作用在固相就对两种聚合物进行了有效分散和就地增容，在特殊的加工温度下，可得到与使用pp唱mah增容剂的共混体系相似的微相结构，分散相尺寸较简单ppffia |
- Similar Words：
- "增溶性" English translation, "增溶质" English translation, "增溶作用" English translation, "增容" English translation, "增容，膨胀" English translation, "增容剂指数" English translation, "增容作用" English translation, "增肉量" English translation, "增肉系数" English translation, "增乳的" English translation
|
|
|
