启动压缩机 meaning in English
auxiliary compressor
starting compressor
Examples
- The compressor delay when power on is set by f20 , for example , 3 minutes , the controller does not start the compressor within 3 minutes after power on
设定，假设为三分钟。则控制器刚通电的三分钟之内不会启动压缩机。 - Thus you can ensure that the boot alternation is over 3 minutes after halt , so it can prevent to breaking the compressor as a result of frequent boot
另外控制器刚通电的三分钟之内也不会启动压缩机，这样在突然停电再来电的情况下也能保护压缩机。 - In addition , the controller doesnt boot the compressor within 3 minutes after turning on the power supply , thus the compressor can also be protected in the state of power cut and then power on
另外控制器刚通电的三分钟之内也不会启动压缩机，这样在突然停电再来电的情况下也能保护压缩机。 - Micro - controller has compressor stopping counter , when compressor stops , this counter begins to count . if running compressor next time , first check this counter , if reach the 3 minutes , compressor runs , and if dont reach 3 minutes , waits to the 3 minutes , then runs
控制器内有一个“压缩机停机计时器” ，当压缩机停机时开始计时，下一次启动压缩机前首先检查这个计时器，如果已满三分钟则立即启动压缩机，如果不满三分钟则等满三分钟再启动。 - The controller contains a compressor halt calculagraph , and it begins to time when compressor stops , the program first check the calculagraph before starting the compressor next time , the program will immediately start the compressor if the calculagraph reach 3 minutes , if the calculagraph doesnt reach 3 minutes , it will start again when the calculagraph reaches 3 minutes
控制器内有一个“压缩机停机计时器” ，当压缩机停机时开始计时，下一次启动压缩机前首先检查这个计时器，如果已满三分钟则立即启动压缩机，如果不满三分钟则等满三分钟再启动。这样可以保证停机后再启动间隔大于三分钟，防止频繁启动损坏压缩机。