分时复用 meaning in English
tsm time sharing multiplex
Examples
- The design theory of the thesis take practicability for principal objective , use transmitting - receipting transducer , by means of optical time division multiplexing ( otdm )
本课题设计原理以达到更优的系统实用性为目的,尝试采用收发一体超声波换能器,四路轮巡的方式分时复用四路收发处理电路。 - In communication function the winsock interface was adopted to coding so that the software can be run on more operating systems . this paper proposes a vr - based telerobotic system for providing both visual and rapid information . the proposed system reduces the influence of time - delay on real time
)通讯信道中的多种信息分时复用传输；采用visualc + + 6 . 0的winsock网络编程接口实现网络通讯功能；为了使用户获得良好的交互界面，设计了基于虚拟现实的交互方法，双向通讯结构可以降低传输滞后对系统实时性的影响。 - Two 3 - frames - grained scheduling policies are suggested to make good trade - off between processing demands and on - chip buffer demands in software decoding implementation . a static time division multiplexed scheduling / dynamic fixed priority arbitration based 2 - level hybrid arbitration scheme , incorporated with synchronization control , is introduced in this paper to utilize the bus bandwidth effectively and lower on - chip buffer demands in media soc
提出了一种基于静态分时复用调度动态固定优先级仲裁的混合二级总线仲裁策略，通过分割总线时间片静态调度媒体数据流dma传输，使之与解码流程同步配合，有效地分配和使用总线带宽，降低了片上数据缓存等硬件开销。 - In this section , with time _ sharing method and the symmetry of sine wave , the look - up table needed to generate three - phase sine wave is reduced to one twelfth of the table before , and the optimization will have no any effect on precision , at the same time , the generation way of the monopolar spwm is improved
在这一部分，还对产生二相正弦波的正弦表进行了优化，利用分时复用和正弦波的对称性，把所需的正弦表减少为原来的1 / 12 ，并保持优化后的精度不变。同时改进了单极性spwm的产生方法。 - Firstly , this paper submits three implementing method of pulse compression processor after analyzing signal form used in system . according as design index requested by physical system and fpga resource status , this paper compares relative merits of three plan and determines to use mac method in time domain . in this method , single mac operation module is used by time - sharing to complete 16
本文从分析系统使用的信号形式入手,提出了3种脉压处理器的实现方案,比较了各方案的优缺点,根据实际系统提出的设计指标和fpga的资源情况,最终确定使用时域mac法,利用单个mac运算模块分时复用实现16通道的脉压处理。